EMBEDDED SYSTEM PROJECT ABSTRACT 11-Bus Automation System Using GSM and GPS

Bus Automation System

 Using GSM and GPS

                            

Abstract

            This project is used to automate the bus.  The objective of the project is achieved through Microcontrollers, GSM, GPS and other required semi conductor devices. The hardware is to be implemented using dsPIC30F4013 microcontroller. The bus has a centralized monitoring unit which displays the Engine temperature, fuel level and Bus location. It also has a Vibration Sensing unit which senses the accident, and sends a message to an emergency number.  Since it has GPS, it can know the bus stop and provides an alarm before the bus reaches the stop, so that the passengers can know the stop before it arrives.

            The Hardware unit includes

1)    dspic30F4013 Embedded Controller

2)    GSM Modem

3)    GPS satellite Receiver

4)    Power Supply +5vDC, +12Vdc

5)    MAX 232 IC

6)    Thermistor for sensing Temperature

7)    Infrared Sensors for fuel level

8)    Vibration Sensor for accident sensing

9)    LCD Display

GPS

As shown in the above pictures, ProGin SR-92 is a low-power, ultra-high performance, easy to use GPS smart antenna module based on SiRF’s third generation single chip.  Its low power consumption and high performance enables the adoption of handheld applications. The slim design allows SR-92 to be placed on top side of the housing to have best GPS signal reception. The 5-pin I/O interface is then connected to the main board with either connector or wire soldering.  The integrated antenna design helps reduce the RF and EMI issues to minimum. Fastadoption and high yield production becomes possible.

The power control feature is very convenient to turn on/off power via GPIO control pin. It’s especially useful in cases such as to turn off power as the user just wants to watch a movie and GPS function is not needed in the PMP case.

Not only handheld but also any other GPS applications can share the following major features of SR-92.

_ Easy adoption with best performance

_ Integrated antenna and EMC protection

_ Built-in backup battery allowing hot/warm starts and better performance

_ No external component demand, just connect and use.

_ Minimum RF and EMI efforts

_ Small size of 18 (W) x 21 (L) x 7 (H) (mm) with patch antenna of 25x25x4mm.

_ High tracking sensitivity of -159dBm

_ Low power consumption of 40mA at full tracking

_ Hardware power saving control pin allowing power off GPS via GPIO

Thermistor:

            Thermistor Used to sense the temperature

Infrred Sensor:

            Used to identify the Fuel level

Vibration Sensor

            Used Senses any vibration above certain level

Power Supply

            Provides +5vdc and +12V dc power supply to the units

LCD display

            Used to Display the events(LOCATION DISPLAY)

MAX232

            Used to convert the TTL signal to RS232 level signals

 CONTACT:
MEGATECH
NO7,KANNAN AVENUE 1ST CROSS STREET,
MUDICHUR ROAD,OLD PERUNGALATHUR,
TAMBARAM WEST-CHENNAI 63
(NEAR HERO SHOWROOM,ANNAI ARUL HOSPITAL)
TEL:044 22761990
WHATSAPP:98402 34766
MOBILE:81444 34766,9659246311
WEBSITE: http://megatechallprojects.blogspot.in/
EMAIL: megatechallprojects@gmail.com